Support opinion.
The crankshaft sensor signal on this engine should look different.
Like this example.
If Your question is about the shape of the signal at high RPM,the tooth signal really becomes triangular.
Ok, so this is a normal signal shape at high rpm. The specs on this car says 0-60 in 10.3 sec. I am getting 15.6 secs with RON 95 gasoline. Customer is reporting lack of power. What is the maximum calculated mass air at WOT? At 6000 rpm with WOT I get: 46 km\h in 1st gear; 74 km\h in 2nd gear; 116 km\h in 3rd gear. Also at WOT accelerating Lambda is around 0.6-0.7.
the engine runs so there wont be much wrong with Crank Sensor unless you are getting a code for it.
As for fuel consumption, 0-60 etc then that only applies when the car is tested. those figures can normally not be achieved when the car is new.
You will get sucked into a black hole with that job
Look at your Short & Long term fuel trims, temperatures etc then jog it on to someone else to waste time with
Thanks. Have to say that I agree with you. The only other thing I found was spark plugs. I replaced them and returned the vehicle. Customer called the next day to say that she sees a definite improvement.
Thanks for the advice and waveforms, it prevented me from going too far down the rabbit hole.