Post
by terbo »
Hi,
The Mondeo of Co-Worker misfires at almost every accelaration.
We only had a few Minutes because of his Wife and Child,sitting in the Car
we took a few Samples, that don´t look good.
I connected a Sekandary Probe to the Coil Wires and the Amp Clamp to
the Common Coil (3-Pin Connector)
On Both Cyl.1+4 there were these "bad" looking patterns at almost
every Snap, and on Cyl. 2+3 they all looked fine to me.
The Sparkplugs were replaced last week.
I would think this should be a bad Coil ?
Greets Chris
-
Attachments
-
- 3-1.psdata
- Cyl. 3 + Coil
- (963.23 KiB) Downloaded 669 times
-
- zyl4.psdata
- Cyl. 4 + Coil
- (974.2 KiB) Downloaded 655 times