Usually try to use efficiency battery tester special.
I wanted to try to test pico diagnostics but in my opinion you should correct stamps.
Battery EN 800A can not be good.
With internal resistance by 7.47mohm had to be put red dot
Internal resistance of a battery 800A EN must be less than 4.7mohm.
Hi Steve
Before the test battery was charged.
Usually use digital tester for batteries
Table on the edge of the internal resistance battery in relation to their capacity, is inside my Motor tester.
Sa to tea does not mind the next time I happen battery no good, I can insert motortester test, and test with pico, to see differences
That would be great if you don't mind comparing the two tests on the same battery and displaying the results with the table for internal resistance values.
Sorry Luca I assumed the battery was not fully charged from the results obtained. "Good but recharge"
It would appear then that the result claimed the battery required charging when not necessary?
Can I ask if you had the latest software for this test?
Thanks again for the valued feedback and I look forward to the comparison results