Search found 40 matches

by landroverman1958
Wed Jul 25, 2018 7:49 pm
Forum: Help me fix my car
Topic: Mini r57 p0087 low fuel pressure
Replies: 3
Views: 814

Re: Mini r57 p0087 low fuel pressure

Do you know i,m sure i,m getting slow in my old age if i didi,nt read in my post saying about primary pressure,presubably1!!!!! :roll:
by landroverman1958
Sat Jul 21, 2018 7:43 am
Forum: Help me fix my car
Topic: Mini r57 p0087 low fuel pressure
Replies: 3
Views: 814

Re: Mini r57 p0087 low fuel pressure

Good morning,why dont you do a similar test on the rail sensor as the pcm does when the key is turned on using voltage?it is probably a piezo resistive sensor and will be three wire, reference,signal and ground,Most likely a 5v ref ,that is presuming you have good primary pressure to your high press...
by landroverman1958
Sat Jul 14, 2018 7:13 am
Forum: Help me fix my car
Topic: Mitsubishi L200 2.5 Diesel
Replies: 1
Views: 662

Re: Mitsubishi L200 2.5 Diesel

Good morning,I have seen on this type of engine if it is a single cam 2.5diesel the pin shear off locating the cam sprocket allowing the camshaft to move relative to the the drive pulley,have to got a code for syncronisation as ok crank to camshaft?
by landroverman1958
Wed Jul 11, 2018 6:14 am
Forum: Help me fix my car
Topic: non start, range rover p38
Replies: 21
Views: 3356

Re: non start, range rover p38

Good morning i woulld say to see full amplitude of the crank back probe both crank wires,secondly maybe if the amplitude is the ok the air gap for the crank is to large,You should beable to generate a spark using a test lamp or make the injectors fire using the test light to subtitute the crank sens...
by landroverman1958
Wed Jun 27, 2018 5:47 am
Forum: Diagnostic discussion
Topic: Renault Kangoo K9K diesel no start
Replies: 3
Views: 895

Re: Renault Kangoo K9K diesel no start

Hi just a thought crack injector nuts to purge any trapped air,i have seen this cause a non start issue,
by landroverman1958
Sat Feb 24, 2018 8:58 am
Forum: Diagnostic discussion
Topic: Nissan Navara engine cuts out at idle
Replies: 7
Views: 10187

Re: Nissan Navara engine cuts out at idle

Hi good morning are you sure the crank sensor is not breaking down?it certainly looks like it is,is it possible to use a hot air gun or freeze spray to check?
by landroverman1958
Sat Jan 13, 2018 9:53 am
Forum: Help me fix my car
Topic: Volvo V70 VVT-solenoid trace
Replies: 14
Views: 6556

Re: Volvo V70 VVT-solenoid trace

Hi have you checked the oil level?oil level is very important for the vvt,also there is probably a criteria to be met before the vvt operates,engine rpm over a certain speed,also check the duty cycle to see if it changes with rpm,it may be the oil screen of the vvt solenoid may have a blockage or th...
by landroverman1958
Sat Dec 09, 2017 11:58 am
Forum: Help me fix my car
Topic: BMW E60 520d intermittent non start
Replies: 1
Views: 812

Re: BMW E60 520d intermittent non start

Hi just check your low pressure input to the rail,it should be 3.5 to4.0 bar,if you have a scan tool it will be shown in data pids rail pressure sensor for plausability of .5volts @ koeo or koer at 1.12volts running at idle,should go to 3+volts on a snap,
Any fault codes relative to low pressure?
by landroverman1958
Tue Nov 07, 2017 7:16 am
Forum: Diagnostic discussion
Topic: Chevrolet Aveo A12XER
Replies: 8
Views: 3199

Re: Chevrolet Aveo A12XER

Good morning,having looked at your wave form,in cylinder,it looks very similar to one taken by Lead daignostics on you tube of a volkswagen with a valve timing issue,
Regards PHicks,
by landroverman1958
Sun Sep 03, 2017 12:10 pm
Forum: Diagnostic discussion
Topic: Non-starting Cayenne
Replies: 9
Views: 3974

Re: Non-starting Cayenne

Hiya,as stc has mentioned,there is a sensor in the sump area which will stop the engine starting if there is an oil pressure problem,which also will disable the fuel pumps, i found this out on a cayenne turbo setember 2004 model,ther is information available on identifix in usa, :wink: i hope this i...