600amp clamp problem

Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
Post Reply
Damian Mc Bride
OneWave
OneWave
Posts: 39
Joined: Sat Sep 03, 2011 8:50 am

600amp clamp problem

Post by Damian Mc Bride »

Hi i tried to use my 600amp clamp(TA019) yesterday, when i switch it on it reads off the scale on 600amp setting, or reads 5.6volts on voltage scale without being connected to car :cry:
My question is can these be tested/fixed or is it not worth the bother should i just order a new one.
I did open it last night but didnt see anything that looked damaged so put back together again.
Ps the first thing i tried was a new battery and still the same.
Regards Damian

Damian Mc Bride
OneWave
OneWave
Posts: 39
Joined: Sat Sep 03, 2011 8:50 am

Re: 600amp clamp problem

Post by Damian Mc Bride »

Ordered a new one today
Damian

Post Reply