Injector Pulse Monitoring

Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
Post Reply

Injector Pulse Monitoring

Post by dhegge » Fri Oct 17, 2003 2:38 am

Newbie PICO User:

I noticed today that monitoring a non-repetive injector pulse waveform with the PICO scope is a little more difficult than I expected. I have always used an Analog scope in the past and had no problems. I am sure that this is because it is difficult to trigger off of a non-repetive signal? Any ideas or suggestions on how to improve this?


User avatar
Posts: 384
Joined: Wed Nov 20, 2002 4:19 pm
Location: Washington State USA

Post by Autonerdz » Fri Oct 17, 2003 4:12 am

Hey Doug,

If it is a negatively controlled injector circuit, try setting up the trigger falling at say 2 volts, put a negative 10% delay on it and use single trigger to capture one event or repeat trigger to continue capturing each time trigger is crossed. Adjust time base to say 2ms/div to start with.

Hope this helps :shock:
Tom Roberts
(The Picotologist)

Post Reply