Ford Focus 1.6 Zetec SE MAP signal

Ask for and share advice on using the PicoScope kit to fix vehicles here.
Avdr
TwoWaves
TwoWaves
Posts: 157
Joined: Sun Jan 08, 2012 9:25 am

Re: Ford Focus 1.6 Zetec SE MAP signal

Post by Avdr »

Be that as it may, do you have any info on the sensor?

Andy

User avatar
Robski
Advanced User
Advanced User
Posts: 598
Joined: Tue Sep 14, 2010 6:36 pm
Location: Yorkshire

Re: Ford Focus 1.6 Zetec SE MAP signal

Post by Robski »

Avdr wrote:Be that as it may, do you have any info on the sensor?

Andy
Not without the engine code, then it would only be the pin-out, then from the signal you get would be obvious whether it is analog or digital.

Avdr
TwoWaves
TwoWaves
Posts: 157
Joined: Sun Jan 08, 2012 9:25 am

Re: Ford Focus 1.6 Zetec SE MAP signal

Post by Avdr »

Fair enough, thanks for the interest.

All I've got here to go on is that the two wires into the ECU are pins 25 and 49,though I have no way of knowing which is responsible for which data, and its not certain that it's correct at all.
It identifies the system with MAP, as being 'Phase 3 &4 W/o HVAC'

User avatar
Robski
Advanced User
Advanced User
Posts: 598
Joined: Tue Sep 14, 2010 6:36 pm
Location: Yorkshire

Re: Ford Focus 1.6 Zetec SE MAP signal

Post by Robski »

49 = Signal in from MAP pin 4 MAP
25 = Signal in from IAT pin 2 MAP

This is not 100 % as no engine code.

Post Reply