Recommended requirements for PC and the Automotive Kit

Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
Post Reply
Richard Cohen

Recommended requirements for PC and the Automotive Kit

Post by Richard Cohen »

Could you please tell me what you would suggest the lap top specs (i.e. ram,proccesor speed,hard drive size) should be to take full advantage of the Automotive kit. I work on mostly domestic (North American) and Asian vehicles and specialise in engine, transmission, ABS, and other electronic control systems.

Thanks
Richard

User avatar
matthew
OneWave
OneWave
Posts: 18
Joined: Wed Sep 25, 2002 9:35 am
Location: Cambridgeshire, UK

Minimum Laptop Specification

Post by matthew »

Any modern Laptop will be fine for use with the automotive kit (I'm assuming that you will not be aiming below a pentium class processor).

The minimum specs are more likely to be governed by how fast you want windows to run rather than our software. I would, however, strongly recommend that you choose Windows 98, 98SE or Me (preferably the latter). These can have a speed advantage with our products.

...also, when you buy the laptop, ensure that it has a parallel port (or purchase one of our USB-Parallel Port adapters).

Best Regards,
Matt Everett

Pico Software Engineer

Steve

It doesn't take a fancy system to make this work.

Post by Steve »

For what its worth, I am currently using the ADC212-100 with an old 486-33 laptop with 16MB RAM, parallel-port interface, WIN95OSR2,
260MB HDD. (Sharp PC-8650)

I believe the ADC212/3 is basically the same thing, just not as fast or deep. I use mine for watching motors on robots and switching power supply startups, which take a very long record length to provide me useful information.


One restriction I have noted is when I take a substantial sample ( say, greater than 1000 readings ), there is a delay as the data transfers. Like a second or so.

If I take it up to the 32K sample/channel limit of the ADC212/100, I may have to wait several seconds for the data to transfer. I kinda expected that. Some of those files are slightly over 100K. My laplink software did not do any better on a file of that size over the parallel port. ( This limitation does not concern me that much, as it takes me much longer than that to view and think about the data I see ).

On the bench, I have been using a Pentium 133/WIN95OSR2/32MB RAM with very good results, but around the robot, I like running the whole setup ( laptop and digitizer) from a 12V battery to eliminate any ground loops that might contaminate my measurements.

On the faster machines, you get more of a live display. From what I have seen, it appears the point of diminishing returns seems to be around a 300MHz Pentium/WIN98.

Beyond that, it looks like the primary limitation is data transfer speed across the parallel bus.

I do take a little performance hit for using a 486, but for what I am doing, its all I need. But I also think this is also the bare minimum one can get away with.

User avatar
matthew
OneWave
OneWave
Posts: 18
Joined: Wed Sep 25, 2002 9:35 am
Location: Cambridgeshire, UK

Pentium Class Processors

Post by matthew »

You're indeed correct, you can run the software / hardware on a 486, the minimum requirements are detailed here; and it will run quite happily.

... but as you correctly suggest, there can potentially be a small performance penalty on very old systems which is why I tend to recommend pentium class processors :wink:.

You may also notice improved performance on Win 95/98/Me PCs over Win NT/2000/XP PCs though, due to the internal architecture of the operating system.

Best Regards,
Matt Everett

Pico Software Engineer

Post Reply