lost signal

Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
Post Reply
johnchad
Newbie
Posts: 3
Joined: Sun Apr 23, 2006 10:34 pm
Location: yorkshire

lost signal

Post by johnchad »

hi admin, tried to use scope to look at lambda sensor but seem to have lost our scope pattern? it just flat lines. connected to air mass meter and same result. Any ideas - last used scope looking at primary ign systems and crank sensor no faults then. Red light at front of scope comes on then goes off - must confess not noticed this before. :oops: thanks in advance John

davidj
OneWave
OneWave
Posts: 24
Joined: Wed Oct 11, 2006 8:50 am
Location: St. Neots, Cambs, UK

lost signal ?

Post by davidj »

Hi John
Set to ±20V range and measure across the battery terminals to do a basic function check on the scope.
I have sent you pm for more details.

Regards,
David
Regards,
David

Post Reply