If you have any questions prior to purchasing the kit post them here.
yesterday the new Picoscope 4425A is arrived at my workshop . I´m very happy now.
So i started to work with and I want to take a look at diesel with piezo injectors <, we all know these could be very high.
At my old scope I used the Attenuator to measure the Voltage but now? I know the bnc-cables form the older scope´s are connectable but the bnc attenuator between the BNC+ connector form scope and cable feel very unusual and wierd to me
Maybe I had overlooked something but better save than sorry
Regarding attenuation you have several options
Depending on the kit you have purchased (assuming you have purchased a kit) for BNC+ attenuation you would use the 10:1 Scope probe here https://www.picoauto.com/products/test- ... cope-probe. This probe is included in all kits accept the starter kits
Alternatively you can continue to use a standard BNC x1 test lead with an additional attenuator https://www.picoauto.com/products/test- ... attenuator
Finally, you can also use our BNC high impedance probes https://www.picoauto.com/products/test- ... 00-mhz-bnc
One final note, with all the above attenuated probes/options, only the signal path is attenuated, not the ground
I hope this helps, take care.......Steve