Hi,
Can anyone help me with a scope pattern and test or workshop manual for Saburu Legacy, 2004,Ez30 motor, 3.0l non turbo.
I need pattern, specs, wiring diagram for test front and rear oxygen sensor per bank.
Regards
John
Saburu Legacy
Ask for and share advice on using the PicoScope kit to fix vehicles here.
Post Reply
1 post
• Page 1 of 1
Return to “Diagnostic discussion”
Jump to
- Introductions
- Automotive kit hardware
- ↳ Charging Circuits
- ↳ Current/Volts Idling (12V)
- ↳ Current/Volts Idling (24V)
- ↳ Alternator AC Ripple/Diode Test
- ↳ Ford Focus Smart Alternator
- ↳ Petrol
- ↳ Diesel
- ↳ Current/Volts Idling (12V)
- ↳ Current/Volts Idling (24V)
- ↳ 1 Wheel
- ↳ 2 Wheels
- ↳ 4 Wheels
- ↳ Digital
- ↳ Analogue/Analogue
- ↳ Analogue/Digital
- ↳ Air Vane
- ↳ Digital
- ↳ Hot Wire [Petrol]
- ↳ Hot Wire [Turbo Diesel]
- ↳ Boost Pressure Sensor
- ↳ Hall Effect
- ↳ Inductive
- ↳ AC Excited
- ↳ 5V
- ↳ Vauxhall Simtec
- ↳ Hall Effect
- ↳ Engine Cranking
- ↳ Engine Running
- ↳ Hall Effect
- ↳ Engine Cranking
- ↳ Engine Running
- ↳ Common Rail Diesel
- ↳ Knock
- ↳ Titania
- ↳ Zirconia
- ↳ Zirconia with Heater
- ↳ Zirconia Pre & Post Cat
- ↳ Analogue (Petrol)
- ↳ Analogue (Turbo Diesel)
- ↳ Digital
- ↳ Throttle Potentiometer
- ↳ Throttle Switch
- ↳ Hall Effect
- PicoDiagnostics software
- PicoScope 6 Automotive software
- PicoScope 7 Automotive software
- PicoDiagnostics NVH
- Diagnostic discussion
- Heavy Duty and Off Highway
- Electric Vehicle
- Case studies
- Help me fix my car
- Best of the web
- Forum feedback
- ↳ News