Hello all,
I have ordered a Picoscope 2204A while I wait for back-ordered 4425A. I have imported probes from Picoscope 7 Automotive over to Picoscope 7 to use on my 2204A. Is anyone familiar with doing this? Is this the right forum?
I have imported a Coil-On-Plug probe with 0-5v scale. And I have a Secondary Ignition probe with 0-50kv scale.
I am using AES Wave COP Paddle pickup and secondary clamp pickup. I am getting some good waveforms. But the measurements change quite a bit depending on what "probe" I select and what pickup I use. Do I need to calibrate my AES Wave pickups? The measurements are also different than what I get on my Snap On Verus also.
Picoscope 7 "probes"
Ask any questions about using the new PicoScope 7 Automotive software here.
Post Reply
1 post
• Page 1 of 1
Return to “PicoScope 7 Automotive software”
Jump to
- Introductions
- Automotive kit hardware
- ↳ Charging Circuits
- ↳ Current/Volts Idling (12V)
- ↳ Current/Volts Idling (24V)
- ↳ Alternator AC Ripple/Diode Test
- ↳ Ford Focus Smart Alternator
- ↳ Petrol
- ↳ Diesel
- ↳ Current/Volts Idling (12V)
- ↳ Current/Volts Idling (24V)
- ↳ 1 Wheel
- ↳ 2 Wheels
- ↳ 4 Wheels
- ↳ Digital
- ↳ Analogue/Analogue
- ↳ Analogue/Digital
- ↳ Air Vane
- ↳ Digital
- ↳ Hot Wire [Petrol]
- ↳ Hot Wire [Turbo Diesel]
- ↳ Boost Pressure Sensor
- ↳ Hall Effect
- ↳ Inductive
- ↳ AC Excited
- ↳ 5V
- ↳ Vauxhall Simtec
- ↳ Hall Effect
- ↳ Engine Cranking
- ↳ Engine Running
- ↳ Hall Effect
- ↳ Engine Cranking
- ↳ Engine Running
- ↳ Common Rail Diesel
- ↳ Knock
- ↳ Titania
- ↳ Zirconia
- ↳ Zirconia with Heater
- ↳ Zirconia Pre & Post Cat
- ↳ Analogue (Petrol)
- ↳ Analogue (Turbo Diesel)
- ↳ Digital
- ↳ Throttle Potentiometer
- ↳ Throttle Switch
- ↳ Hall Effect
- PicoDiagnostics software
- PicoScope 6 Automotive software
- PicoScope 7 Automotive software
- PicoDiagnostics NVH
- Diagnostic discussion
- Heavy Duty and Off Highway
- Electric Vehicle
- Case studies
- Help me fix my car
- Best of the web
- Forum feedback
- ↳ News