Picoscope 7 "probes"

Ask any questions about using the new PicoScope 7 Automotive software here.
Post Reply
Joshasta
Newbie
Posts: 9
Joined: Fri Mar 25, 2022 11:23 pm

Picoscope 7 "probes"

Post by Joshasta »

Hello all,

I have ordered a Picoscope 2204A while I wait for back-ordered 4425A. I have imported probes from Picoscope 7 Automotive over to Picoscope 7 to use on my 2204A. Is anyone familiar with doing this? Is this the right forum?
I have imported a Coil-On-Plug probe with 0-5v scale. And I have a Secondary Ignition probe with 0-50kv scale.
I am using AES Wave COP Paddle pickup and secondary clamp pickup. I am getting some good waveforms. But the measurements change quite a bit depending on what "probe" I select and what pickup I use. Do I need to calibrate my AES Wave pickups? The measurements are also different than what I get on my Snap On Verus also.
Attachments
WYQN8953.jpeg

Post Reply