Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
- Posts: 11
- Joined: Fri Oct 01, 2021 4:06 am
If the 60 amp current probe was left on the main battery cable during cranking, would this induce enough voltage in the probe to damage it?
- Posts: 465
- Joined: Sat Mar 19, 2016 8:23 am
- Location: Netherlands
I don’t think so, we talk about mV and each coil has a magnetic saturation limit.
- Posts: 35
- Joined: Sun Sep 19, 2021 4:20 am
The 60 amp probe will survive this....Actually its reading will max out around 200 amps and these readings are pretty accurate and in line with the measurements of a high current clamp. If you wanted to avoid the signal from the 60A clamp being clipped off than you may want to ac-couple it.