Mitsubishi L200 FRP Waveform

Burt_100 · Post by **Burt_100** » Wed May 20, 2020 7:49 pm

Does anyone have a known good FRP for a 2009 Mitsubishi L200 2.5 TD, I have managed to get the attached waveform but i'm not sure if it is good or bad as I have no comparison, Can anyone help out? The pickup has an intermittent miss at around 2500 - 3000 rpm under full load and is very slow to rev.

Technician · Post by **Technician** » Wed May 20, 2020 10:04 pm

Burt, have you checked the waveform library?

Burt_100 · Post by **Burt_100** » Wed May 20, 2020 10:44 pm

I have checked the waveform library but can’t see anything the same or similar

Technician · Post by **Technician** » Thu May 21, 2020 8:24 am

Burt_100 · Post by **Burt_100** » Thu May 21, 2020 8:54 am

I don’t have iatn

vasek · Post by **vasek** » Thu May 21, 2020 9:38 am

Hi.
If it's useful.

Burt_100 · Post by **Burt_100** » Thu May 21, 2020 5:01 pm

Looks good thanks have you any idea of rise time from idle to full fuel pressure

ronw38 · Post by **ronw38** » Thu May 21, 2020 9:12 pm

Check Pico library Videos Frank Massey's top ten tests #7 it will reveal all . Cheers Ron

Technician · Post by **Technician** » Thu May 21, 2020 9:16 pm

This one;

https://www.picoauto.com/library/videos

PicoScope 7 Automotive

PicoScopes
& kits

Noise, Vibration and Balancing

Breakout
leads/boxes

For vehicle manufacturers

Milliohm

Current clamps

EV kits and
accessories

Pressure sensors

Accessories

PicoScope forum

Contact

Training

Automotive guided tests

Case studies

Newsletters

Training

A to Z of PicoScope

Documentation

Waveform library

Videos

Reviews and awards

Automotive Support Forum