Can I drop a marker while capturing data?

Ask any questions about using PicoScope Automotive software here.
Post Reply
tough24get
Newbie
Posts: 1
Joined: Mon Nov 09, 2015 10:11 pm

Can I drop a marker while capturing data?

Post by tough24get » Wed Jun 29, 2016 5:30 pm

We are trying to identify a misfire that is incredibly intermittent. Rather than just stop recording after an incident, I'd like to drop a marker where it happens and then continue collecting data. Is that possible? If not, I'd like to make a formal feature request in that regards.

Thanks,
Chris J

PicoPhil
Pico Staff Member
Pico Staff Member
Posts: 71
Joined: Thu Dec 23, 2010 11:38 am

Re: Can I drop a marker while capturing data?

Post by PicoPhil » Thu Sep 08, 2016 11:31 am

Hi
Within PicoScope on a waveform capture, we cannot put a marker on screen. I will put this in to development. Don't forget you can write in the notes section about the waveform you see on-screen.

Thanks
Phil R

Post Reply