Hi. Is it black smoke coming from the tailpipe ! If that's the case I would be looking at the MAF sensor and this is despite your comment. You should check the specified vs actual values from the maf sensor it could be reading a high MAF value. The diesel particle filter is cleaned and my first thou...

The dtc you are referring to are related to heater circuit of the oxygen sensor - so check the resistance of this circuit which should have a resistance between 1 to 5 ohms. You could also check how much amps this circuit are consumeing with a current clamp around the feed wire to sensor. Regards Kim

That's also my experience after I installed the latest software. After some troubleshooting I found a solution to this problem - just change your regional language to danish - then it works flawless. I´ve have send a bug report to picoscope, so they know there are problem with this software version....

Hi victor2k I have read some of your previous posts, and I can miss or overlook this question. From my experience with the exhaust temperature sensor the best fit was at 5th order in Curveexpert but can we use this 5th degree in "table lookup" ? Of Course, this can be used in the picoscope lookup ta...

Hi BTW what version of Curveexpert are you using ?. The picture of the residual report looks a bit different than my version - I'm using Curveexpert Pro version. Your data values from your latest plot are they taken from a datasheet or are they actual values that have plotted into your graph and by ...

Hi victor2k The only way to use my method is when you have the correct temperature / resistance specification of that particular exhaust temperature sensor you are using. If you have this it's possible to create a lookup table that you later can export to the picoscope. It seems that you already hav...

Hi. It's really simple to connect to this sensor. Connect the red test lead to the signal wire (PIN 2) and the black test lead to ground of the sensor which is (PIN 1) as shown on the above picture. Sorry - I don´t have any picture of this setup. I hope this explanation was of some help to you. :win...

BTW that little tip you gave me here worked perfect.

Thanks a lot Volrem.

Regards
Kim

Hi Kudugar I looked at your latest upload which seen with my knowledge looks fine and yet did I find something that maybe could be a problem. I´m here talking about the reference mark at the flywheel and the position of the missing two teeth which according to my information should be 60 degrees bef...

Thank you for this information - Volrem I remembered that this is not the first time I've had this problem, but in another software version. At this point, it was possible to solve this annoying problem with this comma by using another keyboard character, but now there no solution to this problem !!...