Search found 337 matches

by victor2k
Wed Oct 19, 2016 9:14 am
Forum: Diagnostic discussion
Topic: Volvo v70 misfire
Replies: 7
Views: 9045

Re: Volvo v70 misfire

Hello,
Or check the cylinder pressure waveforms for all cylinders to see the wear of exhaust camshaft.
Regards
by victor2k
Tue Oct 18, 2016 7:05 pm
Forum: Diagnostic discussion
Topic: Audi A4 BLS cam vs crank sync
Replies: 3
Views: 5391

Re: Audi A4 BLS cam vs crank sync

The faulty camshaft sensor was the cause of DTC. :cry:
by victor2k
Mon Oct 17, 2016 8:31 am
Forum: Diagnostic discussion
Topic: CanBus on nissan Qashqai
Replies: 10
Views: 25773

Re: CanBus on nissan Qashqai

Hello,
Try to check the DPF sensor hoses/tubes for blockage if your sensor work ok on the table
Regards
by victor2k
Sat Oct 08, 2016 12:29 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Re: Ford Focus 1.6TDCI not starting

Hello, Until now I can't make a copression test(I need to take out injector 2 and make an adapter for my pressure sensor). But I need your opinion about the intake pressure and crankcase pressure variation. In my opinion the intake valve from cyl 1 not close very well,the pistons rings not have loos...
by victor2k
Thu Oct 06, 2016 2:25 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Re: Ford Focus 1.6TDCI not starting

ECU is Bosch 0 281 011 701 /4M51-12A650-YD The injectors and wires was checked -I have 0,3 ohm resistence of coil,without short to gnd or + The supply also was checked. Why I have only 4 injection on every injector? With KTS I captured the rail pressure,engine speed and corelation of injection with ...
by victor2k
Thu Oct 06, 2016 2:18 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Re: Ford Focus 1.6TDCI not starting

Hello,
I have a new set of values...
Relative compresion is BAD(I used a 24v/5w lamp instead of injector1 coil for reference).
ECU was knocked and sealed.
Car start only with spray!
by victor2k
Wed Oct 05, 2016 8:07 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Re: Ford Focus 1.6TDCI not starting

Hi ,forgive me Viktor with the dtcs cleared the car will start? .When it wont run you get the 2injector circuit dtcs and the glow plug relay and glow plug monitoring dtcs all together?. I cant open the psdata as I'm not near my laptop . I will asap . When it doesn't run what's the frp and do the in...
by victor2k
Wed Oct 05, 2016 5:28 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Re: Ford Focus 1.6TDCI not starting

Victor what description do you have for those codes - I have Injectors and Glow Plugs ?? Is that capture taken with spray to start it ? If so can we get another trace with Rail Pressure Sensor on Channel D but without the spray and a little more time across the screen. Hello, performance of injecto...
by victor2k
Wed Oct 05, 2016 3:26 pm
Forum: Diagnostic discussion
Topic: Ford Focus 1.6TDCI not starting
Replies: 16
Views: 34618

Ford Focus 1.6TDCI not starting

Hello, I have a 2005 Focus 1.6 TDCI with starting issue: I have the injectors curent only for 5-7 seconds,rail pressure is 32 MPa,engine not start. Using a start spray the engine start and stop.No back leak at injectors. In fault memory I have:P1552 ,P1554,P1395,P138B. When the fault memory is empty...
by victor2k
Thu Sep 29, 2016 7:24 pm
Forum: PicoDiagnostics software
Topic: Battery test issue in Pico 6.11.12
Replies: 9
Views: 22663

Re: Battery test

The same battery was tested with same setup and the result was 994 CCA capacity,only based on 12,6 v detected at the start of test?23-24% diference based only on the state of charge? My friend's car is a Chrysler 300C what show at the morning start many CAN faults, engine and transmission work in li...