Our mind can really play bad tricks
This is the reason why we shouldn't work and use the phone simultaneously

http://www.youtube.com/watch?v=Rf3KcQl0WRU

"Hard to believe this needed two cam sensors, so I had a look at scan data to see if they where in synchronized with the cam sensors and with scan data it said yes, in sync .. ok so I set up the Pico scope to see what's going on. Because with these two codes were not clearing ... " Hi everybody Coul...

hijakd wrote:Energize the egr valve and check that it's opening and closing,if it's stuck open you will have a rough idle/stall

Hijakd is pretty right, is exactly what Mr. Danner would do

My English is poor, and the translator helps me a little, I do not know if you speak of an oscilloscope, or advertising of sweets :lol: ...... but to me pice both ideas and I'm very curious :shock: . with estimate Ha Ha :D Steve is talking about the thinking process and our need for extra sugar/fue...

Hello Chris, welcome aboard.
For sure this is the best place to give and take knowledge about diagnostics.

Dario Caraballo

Hi Steve Thanks for answering, now it is clear, actually I already followed your instructions and works perfect. It is exactly what I wanted it to do. BTW. What is the best trigger and settings for crank signal? Kind regards Dario Not even an apology or reply for Tom even though he gave you a tip ?...

Hi Steve

Thanks for answering, now it is clear, actually I already followed your instructions and works perfect. It is exactly what I wanted it to do.

BTW. What is the best trigger and settings for crank signal?

Kind regards

Dario

Hello KIm I took a look to your wave form it is quite right, but I mean something more accurate like that, I know that with Pico we can do it. Check this shot so lets see how we (I mean all of you guys in this forum) can figure out how to "improve it" as Autonerdz have. Lets see this captures from A...

Hello Kim Thanks again for answering. You are right, it is 60-2 teeth case. I will take your advice and try again. One mistake a made is to limit the the RPM in my table function to 1000 RPM, now I know why a flat line appears in the upper side of the screen. :oops: I will take a look one more time!...

Hi everybody I have a question about using this sensor as a main reference to nail some glitchs under the bonnet. I need to get rpm from the crankshaft sensor via math channel. As far as I know we have to use the math fuction freq(channel) to acomplish this but all I get is a flat line in my scope (...