Welcome Larry, Did you order your kit from Tom Roberts at Autonerdz? Their resources are second to none. I was very sceptical about them as I am in the U.K. and Autonerdz is America based but they are truly world leaders imvho. Not just for the USA. Yes it’s only my/an opinion. I have been forced to...

No.

Save your money

Join Autonerdz.

Cut above learning, imvvho.

All the response-reports on this thread are just about right Imvvho You can research the K110 clamp and it is as good as reported. I merely stated it's accuracy against a posts uncertainty towards general amp clamps abilities/accuracy. One thing to remember with the AF wideband sensors is, if a faul...

AEMC Instruments is a is a subsidiary of Chauvin Arnoux Inc. page 2 , statement of compliance, http://www.chauvin-arnoux.us/pdfs_aemc/ ... 110_en.pdf

Mine is badged an AEMC K110 and housed in a Chauvin Arnoux case. The attached PDF is a duplicate of my paper manual.

liviu2004 wrote:I doubt that an oxygen sensor can output sufficient current for an clamp amp. Or am I wrong?

I have an AEMC K110 current probe which works very well on AF wideband sensors.

@Ben

What a lovely courteous helpful reply. (Thought I was on Autonerdz for the minute then, not here) Certainly worthy of note imvho.

Picokev.......

M033249

= 1355

The M series Ford code calc is widely available with a google search. Alternatively if you struggle to find it, pm me and I'll assist.

Dcunning35 wrote:If your 100 the crank pin your using is correct and the static timing is bang on we need to explore another reason for the low intake vacuum

And the late ignition event.
There's sommat amiss here with this cars info & symptoms

Hi, I think FYDB is not so incorrect, think that could be. But i don´t know 100%. Where do i find the engine code on this Car ? Partslink doen´t show it with the VIN. Pord Service Page either... When scanning the cars data, The engine code is identified on an AutoSearch together with the VIN when u...

Technician wrote:Thanks for putting in the effort to show and explain the operations of the new software on the Pico scopes Martyn :)

What 'new' software?
The original post is over 5yrs old!