Hello and thank you for the post sorry for the late reply You can use a thermocouple with the 4425 to plot temperature but you will need an interface to provide a power supply The following link https://www.picoauto.com/support/viewtopic.php?p=102342#p102342 discusses this very same subject Once you ...

Hello Jarkko, welcome to the forum and thank you for the introduction It sounds like you have been here for some time behind the scenes and that is absolutely fine As long as the forum is helping someone somewhere, then our collective work and contributions become a resource of "go-to" information ...

Hello Charlie, welcome to the forum and thank you for the introduction Hats-off to you for starting a business after completing your level 3, we wish you all the very best With regards to your PicoScope journey, I am not sure whether you are using our Scope solution, so I have added several links ...

Hello Uli and thank you for the post Our TA144 Microphone sensitivity is 45 mV/Pa The mic is omni-directional Frequency range 20 Hz - 20 kHz The maximum resolvable sound pressure (SPL) is 125 dB SPL However, this is approaching the point of mic "clipping" and so "shop" noise levels into the 130dB ...

Hello and thank you for the post There are constant improvements in place with PicoScope 7 which does include drivers, software and bug fixes You can see these in the release notes for the version you downloaded here https://www.picoauto.com/downloads or here https://www.picoauto.com/support ...

Thank you for the feedback and taking time to share a success story too as this is so important for others to see

I just hoped you did not receive that dash rattle job sheet on a Monday morning after a heavy weekend

Take care.......Steve

Hello and thank you for the post Could you provide the pddata file for the captured data? It would be great to see if the vehicle was accelerating during this capture. T3 can be attributed to a drive shaft (Tripod joint) and will exhibit high levels generally when accelerating (loaded) Could I ask ...

Hello and thank you for the post Could you provide the psdata file for the captured data? I am going to assume Pin 49/69 are either side of our fuel injector (forgive this assumption if incorrect) Would it be possible to retake this capture but with a current clamp around injector 1 using channel C ...

Hello and thank you for the post It is possible the 4223 device you have is a Test and Measurement device and not an Automotive scope Would it be possible to download PicoScope 6 or 7 from our T&M site here and try either build https://www.picotech.com/downloads 1.png If your 4223 device now ...

Hello and thank you for the post I have to agree that searching on the forum can be challenging based on what you describe above We are taking steps to improve the search function and it would good to have your feedback when these have been actioned Our current search options do include an advanced ...