Thank you very much for that.
Will give this ago . Could be exactly what I was looking for.

Regards
Dennis Carey

Advice required Please. Can any one advise if it is possible to zoom in on the voltage fluctuations around a set voltage . I have been trying to monitor the throttle potentiometer outputs between two banks of cylinders. The voltage level at idle is approx 5v but there is a slight fluctuation between...

Hi Alan.
Thanks for the info 50 ohm cables now on order.
Regards
Dennis.

Hi All.

At present I am building a diagnostic cart and wish to install extended BNC cables From my Pico to bulkead connectors. I wish to use BNCto BNC extension cables.
My question is can I use readily available cables or is there spec required ?

Any Help please
Dennis Carey

How did you mark sensor wheels before removal ?

Regards
Dennis Carey

Hi Dave.

Thanks for spending the time to give a reply.

I will take these tips on board when next checking primary/secondary.

Regards
Dennis

I have been attempting to carry out ignition tests on the following vehicle but cannot get an accurate display of secondary ignition patterns ? Vehicle BMW E38 750i 2000mdyr This vehicle is a V12 engine with a control unit for each bank and also has a distributor and set of leads for each bank. The ...

Hi Lee .

Thanks for the support. I will give this a go.

Regards
Dennis

Hi to All. Just carrying out the above tests on a BMW X5. Required to monitor overnight using 60amp clamp on 20 amp setting. The problem was that even with 200secs/div there was insufficient storage time to get through the night. The other problem was the current clamp exhausted the internal battery...