Thanks Ben, I need to get out there on the running engine and get the info with the clamp, works been chaos and I've been running the shop as my manager hasnt been here so time hasnt been on my side. As soon as I can I will upload. Thanks again

Thanks everyone, ended up being out of time after comparing the data and the other shop pulled the unit back out to them.

Well i was able to get another unit and get some readings, i havent been able to compare yet but this one has a dead miss and is worn out but runs.

Thanks Carl and Ben. I know i bore scoped the crank sensor and the tone wheel has some marks on it(The unit had been at another shop before here and they replaced the ring gear, starter and put a new crank sensor in it, fear is they drove it in and chewed it off, but i cant confirm any of this witho...

Ok i got it this time, Such a learning curve finally getting to fully use it.

Thanks, i haven't had time to go back out and try to re run with a shorter time or anything. Here is the link. https://drive.google.com/file/d/1KvlpdOb4Owh_6qdjbtAuC3Nrvs463in2/view?usp=sharing only thing that sticks out is the cmp sensor even though the ckp is the one erroring. Figured out I still ...

So i am chasing a CKP fault on a DT466e (egr motor), I know the checks per Navistar fault 147 are all in spec. I put the scope on it and I haven't been able to find a good wave and i don't have another to compare it too. Can someone led a second set of eyes? Sorry still learning with the scopes.I ha...

On the same topic of SCR problems, we've had a few 6.7 cummins with a fault stating not enough PM sensed. Short story is there was a bad batch of SCRs that werent welded correctly and installed from the factory. Several diesel in the DeF tanks eith horizontal exhausts and the SCR was full of diesel ...

On the cummins nox sensors, x12 logic is horrible. Went in circles on a terex mixer with one(one fleets mix of terex and oshkosh to be exact). But this one unit rapidserve kept saying to throw a nox at it. It had been overlayed(all4) multiple new pins. Finally got the dsfe involved, the inlet nox wa...

Muttnjeff, Thats what my plan is, only glitch is all the trucks i have had are waiters so its limited time with them. Im going to work on it hopefully next week.