Hi. The uninstall and reinstall seems to have done the trick. Thank you guys.

I’ll give that a try. Scope is connected (4425).
I can open it on our home laptop. I installed ps7 on it last night. But not on my work laptop.

Hi Steve,

I’m running the latest PS7 software. Is it a setting on my laptop I need to change that’s not allowing me to access it? I did read through the post but I’m still unsure what I need to do.
PS6 is no longer supported though so I take it this is the reason it kicks me out?

Hi I’m unable to access the waveform library on my laptop, any ideas? In Pico 7 I get this message: Waveform library path is missing or incorrect in the app.config file. Please configure key “WaveformLibraryApplicationPath With a full path to the waveform library executable including extension. Also...

We have. The fault remains the same.

Scott Neal

Thanks. I've never seen the signal before and didn't have a known good one. It just said in ESI that it's a hall sensor, think I jumped the gun a bit fitting a crank sensor as the signal remains the same when it starts and when it doesn't.

Scott Neal.

Hi We have a 2013 Vauxhall Mokka 1.4 A14NET in that cuts out and/or sometimes refuses to start. Seems worse when hot but will also do it when cold. It will crank but won't start. It will then sometimes just start without hesitation and run without any problem, sometimes all day and sometimes only fo...

Hi Mike
I cannot remember my password for this. Can you help me please
E mail is scottydlneal@hotmail.co.uk.

Scott Neal

We tried removing each injector in turn but it still refuses to start. We then removed the glow plugs as a safety precaution to remove compression/combustion just in case and then swapped injector wiring 1 and 2, 3 and 4. The low voltage waveform moved to injectors 2 and 3 so this ruled out the inje...

008518 - Supply Voltage for Fuel Injector Group A P2146 - 000 - Open Circuit Looking for some advice on this one please. The above car cranks, offers to start briefly but then flashes the coil light and stops cranking. It logs the above fault code that clears until you try to start it again. Checks ...