Just to be clear the TA330 is for low frequency smart key antenna/oscillator signals not high frequency wireless remote signals. In my experience you get a signal from the TA330 when you hold the TA330 tip within 12-18 inches of a smart key antenna(oscillator). For example an exterior handle antenna...

No. The TA432 resistance probe is designed to be used with BNC+ connections. BNC+ connections are only found on Picoscope hardware that can apply voltage to probes such as current probes without batteries and the resistance probe.

The Pico 4444 T & M scope uses D9 connections not BNC+.

Click on the magnifying glass, top right of graphical area. When the zoom controls open, look for "1:1". If the 1:1 is grayed out, you are already zoomed out fully showing all data in the capture/buffer. From what I can gather from your images, the dealer tech operating the scope has too little amou...

I don't know how the number in brackets is calculated or what it means. The number in brackets appears when Interpolation is turned on in Preferences. ON=smoothing of line connecting sample points. OFF=no smoothing/ straight lines connect sample points.

Ben, I've been over and over your original post. I've tried to apply your technique to a LIN waveform from a 2018 Lexus. I can get through the LIN decode in Pico, exporting as .csv, saving as Excel workbook, found the applicable table in the AR6000 document and copied it into Excel. The problem I am...

I realize this doesn't answer your question specifically. For parasitic draw, I use trigger "none", then set the timebase according to how long I want to record the data in one buffer/waveform/screen, then verify the sample interval corresponds to the amount of detail I want. Start the scope wheneve...

Hello and thank you for the posts Sorry, I should have clarified the version I used to provide the above screen shots (Version 7.0.103.11746 EA) as seen in image 1 (The version used to open the file displayed) Sorry I should have tried the same tests with the latest EA as that is what you used to r...

Click on More > About PicoScope 7 to reveal the Scope model and Serial number used to acquire the loaded capture Steve, I tried this using PS7 Stable 7.0.80.9125. The software version shown is the current version of PS7 on the PC used to open the .psdata file. The scope model and serial number are ...

I don't know what you mean by the phrase "Snap-On compression adapters." The Pico hose is the best.

https://www.aeswave.com/Foster-2-Series ... p9448.html

My scope does not have isolated grounds between each channel so I cannot do a cam/crank relationship test, ... See the following forum post with a reply by Steve Smith for how to connect your scope inputs and grounds https://www.picoauto.com/support/topic22834.html?&p=103142&hilit=common+ground#p10...