Hi guys,we’ve got a 2010 1.4 diesel fiesta in atm it’s got a P0101 trouble code in the PCM which relates to an air flow meter issue,the AFM is a Continental 4 wire part which I can’t seem to get any sense out of electrically,the four wires appear to be 2 x 12v,1x5v and an earth(sensor unplugged)I ca...

Hi guys I thought I would update you all on this issue I had with the Nissan Juke,after carrying out numerous suggestions on here and basically pulling my hair out we eventually got to the bottom of this problem,turns out the vehicle had recently been fitted with an aftermarket alternator which appa...

Hi Mike I appreciate you trying to help but I’ve removed this pipe(a real nightmare)to make sure 100% that it isn’t blocked and it’s perfectly clear and the pressure sensor reads correctly when the engine is revved,ive checked numerous other things as well including the ones mentioned by Frank earli...

Cheers Steve that’s very helpful,I’ve been looking at this VAN network today with the PicoScope and as you said if you use the standard CAN set up the voltages go over range(because it’s higher than the CAN voltages which are normally 3.5V)so I reset it to 10V range to get the capture which then loo...

Hi there,we have at work the PicoScope 4425 can anyone tell me if this can read VAN network as used by PSA group of vehicles ?...Many Thanks

Cheers Frank much appreciated

Hi there I’ve come across this lambda sensor fault code a few times in the past and found it to be oil contamination in the pcm caused by the oil pressure switch leaking sounds crazy I know but I’d check that if I were you,the oil seems to go down the oil pressure switch wire into the engine compute...

Hi Frank,no the pipe I’m referring to isn’t the DPF sensor pipe it’s the exhaust pressure sensor pipe,tbh I’ve never seen a vehicle with one of these on before and I’m not sure what it actually does,looking in the live data readings I can’t find a pid for it either....Many Thanks

Thanks for taking the time to reply Frank,this code won’t clear although I’m using an Autel maxysis diagnostic machine not the consult(but I have also tried the snap-on modus),the code will clear with ignition on Engine off but as soon as the Engine is started the code returns,spoke to BBA reman who...

Hi there,we have in our workshop atm a Nissan Juke 1.5dci with the ESP light illuminated,there is a code in the ABS module C1130 which reads as Engine signal 1,there are no codes in the Engine module,if I clear the code it doesn’t come back when the ignition is switched back on only when the vehicle...