Having been logged in to the Automotive Support Forum and not finding anything relating to PicoLog I went to the support area for that, my question; do my login details not work out of the Automotive Support Forum

Originally posted in "PICO 6 Software". In the middle of a diag on an older Transit Van with factory LPG (Necam), the LPG system uses a coil signal through a filter for its RPM signal. Fault (engine misfire) is showing up on the LPG diagnostic software as a high spikes on the graph for RPM and jumpi...

Moved to "Automotive kit hardware"

I have a couple of different mains supply units I'll see if any of them make a difference.

Just a quick post, using NVH to check wheel bearings on the ramp. The laptop was running off the mains charger cable, I noticed peaks on the readings at 50, 100 and 200 Hz, puzzled me for a minute because the car was not being touched, then realised mains voltage supply in the UK is 50 Hz, put the l...

Hi Ben using some of this spare time to get into the nitty gritty of the Pico Scope, one of the difficulties I have is with advanced triggers, for example I am working on a 5.7 Jeep. I would like to trigger when the Crank sensor trips out and using alarms record the buffers so I have the pre and pos...

Many thanks for quick reply, I will certainly look into "Deep Measurement", I was hoping to have a live measurement and have tried your suggestion of placing the cursor at the end of the pulse this as you say is erratic but much more stable when I set the resolution to 16 bits than it was at 12 bits...

I am looking for some deeper help with using measurements, frequently when trying to use measurements there is nothing to be seen in the measurement window. For example I am trying to measure a changing injector pulse width, I thought that using the "low pulse width" would be the correct choice but ...

Hi Steve Wow that's what you call a comprehensive explanation, I will sit down and look through it and then try it out on the RR. I wasn't sure where it gave the listing of overall ratios, how that would come into NVH. It would be handy if this info was available from more manufacturers maybe we wil...

Hi all have only just started with the NVH, I am planning to do some classroom work on my old P38 Range Rover (good subject). I have a full breakdown of the gear ratios (attached PDF) my question which would be the correct one's to use with the NVH software?.