Hi all, its been a while since I had this car in and to be honest the only fault I have rectified was split turbo hose.
It is possible that the cylinder 2 combustion pressure was slightly lower because of split turbo hose, this car never came back to me after I've replaced the it.
Thanks
Greg

I hand the chance to see this car back, codes still present so I decision was made to replace the glow plug with new one Beru part. After fitting new PSG one of the fault codes came back straight away, P03A7, it cleared but after running the engine on idle it was coming back. I had no choice, took i...

Thanks, very interesting approach by Vauxhall.
I wonder if there has been any revisions to this bulletin.
At the moment I'm trying to find the way of correct interpretation of waveforms, If the car will get back to me I'll try to take another capture with crank sensor and injector currents.

No, I haven't done anything except scoping the signal, I've got no evidence this plug is at fault. I had very little time with the car and it is no longer in the garage. I've been looking online to find some information about the waveform but all I can find is glow plug manufacturer's pdf documentat...

Hi all, I've got few questions about troubleshooting pressure sensing glow plugs on 2011 Insignia, A20DTH. Symptoms are EM light on and loss of power. After connecting to diagnostics 2 codes were found. P03A7 Combustion chamber pressure sensor Cylinder 2 Differential pressure too high. P03A3 Combust...

You are correct, I just roughly counted the crankshaft notches but yes it is 17 deg out using rulers.

Well this answers my question.

Thanks

Hi all, I'm working on 2006 Focus,1.6 Ti-VCT HXDA EM light on P0341 Camshaft position sensor A range performance. Also P0016 Cam to crank correlation A and P0017 Cam to crank correlation B I have replaced timing belt and intake camshaft gear, timing was out and cam gear had a slack. Previous garage ...

Hi all, I have recently used pico just once, I think it is great, I've got 2 years of experience in using oscilloscopes mainly Snap on based, time to take it to the next level. I'm a bit lost with picoscope user interface as I'm used to Snap On's simplicity, just thinking where is the best way to st...