Scaling a Custom probe's axis uses unhelpful units

Ask any questions about using PicoScope 6 Automotive software here.
Post Reply
ed800uk
OneWave
OneWave
Posts: 19
Joined: Mon Jul 03, 2006 2:24 pm

Scaling a Custom probe's axis uses unhelpful units

Post by ed800uk »

This is more of an annoyance than a bug. I reckon the whole issue of scaling probably needs to be a bit more friendly.

Come to think of it, this display might be from a PSD file saved by R5, and then opened in R6. So it might be more of a compatibility issue.

Here the inverted kilovolt scale retains its "kilo" while multiplying by exponent -3. Which should cancel each other out.

You can see the value at the bottom left of the PDF.

Regards,
Ed
Attachments
weird arith ruler legend.pdf
(83.04 KiB) Downloaded 655 times

Michael
OneWave
OneWave
Posts: 21
Joined: Thu Jul 07, 2005 12:41 pm
Location: St Neots, Cambridgeshire

Post by Michael »

THank you Ed.

We will look into this.
Michael - Tech Support
Pico Technology
Web Support Forum

Post Reply