Polo 1,2 3-Cyl. 2006 BMD - Cylinder drops out

Ask for and share advice on using the PicoScope kit to fix vehicles here.
victor2k
TwoWaves
TwoWaves
Posts: 337
Joined: Thu Jan 28, 2016 7:17 am

Re: Polo 1,2 3-Cyl. 2006 BMD - Cylinder drops out

Post by victor2k »

terbo wrote:Today i took some waveforms at different RPMs,
from Cyl. 1 (no misfires) and Cyl.2 (shutting off).

Maybe anyone sees a cause - i don´t.

If i messure peak to peak, then i get always only half of the real rpm
in the bottom right corner from the Pico-SOftware, is that normal ?
Hello,
The peak pressure in cylinder must be at 15,7 bar(this is a calculated value for the compression ratio 10,3 and specific heat ratio 1,3) without ignition...
And yes is normal to get only a half of real RPM because from peak to peak the crank shaft have 720*(2 complete rotations).
Regards

Post Reply