Thank you for answer Steve.
Unfortunately, in the Pc Diagnostics software I do not have the ability to set my probe that generates a voltage 3000mV at 600A (ratio of 5 mV/A).
Or is it necessary to use in Battery test only probe 600A or 2000A with a ratio of 1 mV/A?
In the PicoScope Automotive software I can adjust my non-standard probe over an item Tools, Custom Probes.
Thanks.
Sorry I was not aware you were using the Pico Diagnostics software where you only have the option to use either
the 600 A or 2000 A clamp (1mV/A)
For this software (battery test) you would need a current clamp with an output matching that above (1 mV/A ) as there is no feature to amend this probe setting within Pico Diagnostics