Ask any non-NVH related questions about using PicoDiagnostics software here.
MAE
OneWave
Posts: 20 Joined: Wed May 01, 2013 7:16 am
Post
by MAE » Thu May 02, 2013 8:20 pm
Yes using the supplied USB cable
Martyn
Pico Staff Member
Posts: 361 Joined: Thu Aug 11, 2011 7:43 am
Location: Cambridgeshire
Post
by Martyn » Fri May 03, 2013 5:53 am
Please post the psdata file so that we can take a closer look.
Martyn
Technical Support Manager
MAE
OneWave
Posts: 20 Joined: Wed May 01, 2013 7:16 am
Post
by MAE » Mon May 06, 2013 2:15 am
sorry im new to pico, is the file you are after a saved image of the scope in operation?
Martyn
Pico Staff Member
Posts: 361 Joined: Thu Aug 11, 2011 7:43 am
Location: Cambridgeshire
Post
by Martyn » Mon May 06, 2013 7:41 am
Yes.
File>SaveWaveform and save as a psdata file then we can open it in the software and look at settings and detail.
Martyn
Technical Support Manager
MAE
OneWave
Posts: 20 Joined: Wed May 01, 2013 7:16 am
Post
by MAE » Wed May 29, 2013 10:35 am
this is a file from hooking the scope straight to battery on the floor not connected to anything, as you can see its all over the place. sorry for late response, been very busy
MAE
OneWave
Posts: 20 Joined: Wed May 01, 2013 7:16 am
Post
by MAE » Wed May 29, 2013 11:03 am
i cant get the file to upload, any help?
Martyn
Pico Staff Member
Posts: 361 Joined: Thu Aug 11, 2011 7:43 am
Location: Cambridgeshire
Post
by Martyn » Wed May 29, 2013 12:18 pm
How large is the file ?
Martyn
Technical Support Manager
RonMcleod
Newbie
Posts: 4 Joined: Thu Aug 26, 2010 8:14 am
Post
by RonMcleod » Sun Jun 30, 2013 1:05 pm
Hi
I had a similar problem and it was because I opened Pico before I plugged the charger into the mains, I found if I hook the Pico up AFTER I plugged the charger in it was fine.
Ron