Voltage Range

Ask any questions about using PicoScope 6 Automotive software here.
Post Reply
aamjad.iqbal
Newbie
Posts: 2
Joined: Wed Jan 16, 2013 3:45 pm

Voltage Range

Post by aamjad.iqbal »

hej!
I am using picoScope4227 with labVIEW.

Is there any possible way that LabVIEW changes voltage range automatically depending upon input ??
as when i have small input voltage like 5mV and voltage range is set to 50mV then output is approximately correct but when i change the voltage range to 1V then error increase. Same way when my input voltage is large like 300mV and voltage range is 50mV, again output have some error.
Actually i want to get any error free output which is only possible that if the voltage range changes automatically according to input voltage.
Can you help me in that ???

regards,

aamjad.iqbal
Newbie
Posts: 2
Joined: Wed Jan 16, 2013 3:45 pm

Re: Voltage Range

Post by aamjad.iqbal »

mV = (ACD count x mV range) / max value (max value = 32764)

I am using this formula to convert ACD to Voltages

Martyn
Pico Staff Member
Pico Staff Member
Posts: 359
Joined: Thu Aug 11, 2011 7:43 am
Location: Cambridgeshire

Re: Voltage Range

Post by Martyn »

This is not an automotive questions and should be on our T&M forum http://www.picotech.com/support/ or sent into support@picotech.com
Martyn
Technical Support Manager

Post Reply