Incorrect Calculations?

Ask any non-NVH related questions about using PicoDiagnostics software here.
Post Reply
rod_au
Newbie
Posts: 0
Joined: Sun Aug 08, 2010 10:11 pm

Incorrect Calculations?

Post by rod_au »

Hi,
I have used this program a lot since purchasing the 4423 Pico.
It has always provided pretty accurate data as far as I could tell in the past as I don't normally do mechanical test to compare the results.

However, the last two releases have been giving me very suspect results. I attached an example of a test made 2 weeks back with the latest software. This morning I installed the older 1.2.1 alongside the new version and opened the same file in both versions of pico diagnostics and you can see clearly that there is something a little askew with the new version. With a mechanical test this vehicle had even compression with a less than 5% variation.
I thought I would bring this to your attention although I am sure you are already aware of the issue.
In the meantime I will resort to the old version, with anticipation of the new release :)

Rod
Attachments
Old Pico Diagnostics
Old Pico Diagnostics
New Pico Diagnostics
New Pico Diagnostics

rod_au
Newbie
Posts: 0
Joined: Sun Aug 08, 2010 10:11 pm

Re: Incorrect Calculations?

Post by rod_au »

Ok, last one.
I tried the two versions again this time with a different file just to confirm the results.

Im done now :)
Attachments
New Pico Diagnostics
New Pico Diagnostics
Old Pico Diagnostics
Old Pico Diagnostics

ziko
OneWave
OneWave
Posts: 21
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Re: Incorrect Calculations?

Post by ziko »

Hi can you send the files please to support@picotech.com and put on the subject for the attention of Ziko, would be interested in analysing the data.

Kind regards
Ziko

Technical Specialist

Post Reply