Buad rate calculation

Ask any questions relating to the PicoScope hardware or kit contents here.
If you have any questions prior to purchasing the kit post them here.
Post Reply
Guest

Buad rate calculation

Post by Guest »

If I measure the High speed can bus and want to figure out its Baud rate
how do I make the calculation. I have measured a bit at 9999ns

ziko
OneWave
OneWave
Posts: 21
Joined: Fri Dec 01, 2006 10:03 am
Location: St Neots

Post by ziko »

Hi and thank you for your post.

I am not an expert in CAN bus however what I can say is that your transfer rate is 1Mb/s. Now depending on the number of bits you have in the signal then your baud rate would be 1000000/x (where x is the number of bits in signal). So you would need to know how many bits there are in your signal since these vary in the CAN bus.

Let me know if you require any further assistance or if this didn't answer your question.

Kind regards
Ziko

Technical Specialist

Post Reply