Automotive Guided Tests

Our PicoScope Automotive software contains over 160 guided tests and includes example waveforms and scope settings. These waveforms were captured using a PicoScope Automotive Diagnostics Kit, find out more about our kits here.  

Home

Pressure transducers

DPF back pressure

The purpose of this test is to check the exhaust back pressure caused by a Diesel Particulate Filter (DPF) during a Wide Open Throttle (WOT) test.

How to perform the test

  • Identify the hose leading from the exhaust system upstream of the DPF to the DPF pressure sensor.
  • Connect a fully charged WPS500X transducer to PicoScope channel A using the supplied BNC to BNC lead.
  • Switch on the WPS500X and wait for the self-test to complete (LEDs will scroll from range 1 to 3 and revert to 1).
  • Disconnect the hose at the sensor and connect the WPS500X to it using the supplied vacuum hose and adapter.
  • Start the engine.
  • Minimize the help page. You will see that PicoScope has displayed an example waveform and is preset to capture your waveform.
  • Start the scope to see live data.
  • Fully depress the accelerator pedal until the engine approaches its safe maximum speed (RPM), then release the pedal.
  • With your live waveforms on screen stop the scope.
  • Turn off the engine.
  • Use the Waveform Buffer, Zoom and Measurements tools to examine your waveform.​

Example waveform

Further guidance

Guide

Diesel engine exhaust gases should flow freely through a DPF during all engine speed and load conditions. However, the filter will always cause some degree of restriction. The degree of restriction depends on the extent to which particulate matter has built up in the filter (i.e. the particulate load within the DPF).

If the engine is functioning properly, without Diagnostic Trouble Codes (DTCs) or faults, and is regularly subjected to the appropriate driving conditions, then DPF regeneratation can take place (either passively through prolonged exposure to sufficient exhaust temperatures or actively through appropriate diesel injection modes) and the DPF particulate load will be low. However, if the necessary conditions do not occur the filter can become excessively blocked and the particulate load will be high. An excessively blocked DPF will cause an excessive exhaust back pressure, when measured upstream of the DPF (i.e. a DPF back pressure).

This test can be used to identify genuine DPF blockages due to excessive particulate loads. You will need to compare your measurements against manufacturer specifications to determine whether or not the peak back pressure is within acceptable limits. The example screenshot in this section compares a waveform with a known bad peak DPF back pressure (230 mbar) against a reference waveform with a known good peak DPF back pressure (70 mbar): The bad DPF back pressure is significantly higher than the known good.

Excessive DPF back pressure can cause the following symptoms:

  • Poor performance (low power).
  • Excessive fuel consumption.
  • Poor starting.
  • Diagnostic Trouble Codes (DTCs).
  • Glow plug or Malfunction Indicator Lamp (MIL) warning lights.

Before carrying out a forced regeneration (or passive or active regeneration via an extended road test) in an attempt to clear a blocked DPF, ensure all engine faults have been fixed (e.g. exhaust temperature sensor or glow plug faults), any DTCs have been cleared, and the Engine Control Module (ECM) software is up to date.

Note: the test provides a momentary diagnostic observation of the DPF back pressure, it is not intended to provide a long-term monitoring solution (i.e. extended exposure to the exhaust gases may cause irreversible damage to the WPS500X unit).

Disclaimer

This help topic is subject to changes without notification. The information within is carefully checked and considered to be correct. This information is an example of our investigations and findings and is not a definitive procedure. Pico Technology accepts no responsibility for inaccuracies. Each vehicle may be different and require unique test settings.

`