Cart
Your cart is empty

General motorbike testing

With most motorbikes it is easiest to take all measurements from the ignition / injection Electronic Control Module (ECM). This is usually located in a weather-resistant compartment under the seat.

1. Remove the seat.

2. Locate the ECM compartment.

3. Remove the two front cover securing pins and ease the unit out so the multiplugs are exposed.

4. Consult manufacturer's data to identify the pin configuration of the multiplugs and the destination of each wire.

Example pin data

AT100-3

Disclaimer
This help topic is subject to changes without notification. The information within is carefully checked and considered to be correct. This information is an example of our investigations and findings and is not a definitive procedure. Pico Technology accepts no responsibility for inaccuracies. Each vehicle may be different and require unique test settings.

Help us improve our tests

We know that our PicoScope users are clever and creative and we’d love to receive your ideas for improvement on this test. Click the Add comment button to leave your feedback.

Add comment

Scroll

PicoScopes
& kits

For vehicle manufacturers

EV kits and
accessories

Noise, Vibration and Balancing

Milliohm tester

Pressure sensors

Current clamps

Breakout
leads/boxes

Accessories

General motorbike testing

Example pin data

Help us improve our tests

Add comment

Guided test: General Testing

PicoScopes & kits

For vehicle manufacturers

EV kits and accessories

Noise, Vibration and Balancing

Milliohm tester

Pressure sensors

Current clamps

Breakout leads/boxes

Accessories

General motorbike testing

Example pin data

Help us improve our tests

Add comment

Guided test: General Testing

PicoScopes
& kits

EV kits and
accessories

Breakout
leads/boxes