Automotive Guided Tests

Our PicoScope Automotive software contains over 160 guided tests and includes example waveforms and scope settings. These waveforms were captured using a PicoScope Automotive Diagnostics Kit, find out more about our kits here.  

Home

Electric vehicles

12 V Renault Zoe Pulse Box

The purpose of this test is to determine the effects the Renault Zoe pulse box has on the 12V battery.

How to perform the test

  • Use manufacturer's data to identify the pulse box circuit fuse.
  • Using a fuse breakout, remove the fuse and place it in the breakout. Fit fuse breakout into fuse position.
  • Connect PicoScope Channel A signal to battery positive and ground to battery negative.
  • Connect high amps clamp to PicoScope Channel B and to fuse breakout.
  • Connect PicoScope Channel C to battery positive or negative whichever is easiest based on accessibility.
  • Carefully route the cable to close the bonnet.
  • Lock the doors of the vehicle and wait 2 mins.
  • Start the scope
  • Unlock and open the drivers door and put the vehicle into Ready ON.
  • Stop the scope once the buffer is full.
  • Use the Waveform Buffer, Zoom and Measurement tools to examine your waveform.

Example waveform

Further guidance

This guided test utilises a trigger which will require the current clamp to be installed on the fuse break out in the correct way. Below is an image of the current clamp on the correct side of the fuse breakout in order for the trigger to be met.

Guide

As this test involves loading the battery we could cause more issues by running the test more than once. Ensuring the setup is done correctly the first time will ensure that we get the capture first time.

The Renault Zoe is unique in that it's the only vehicle seen which has a dedicated device which physically loads the battery before the vehicle is put into Ready mode. This does have some drawbacks. If the 12V battery is weak, a warning light will illuminate the dash indicating to the driver to stop with the words, electric failure DANGER. Some of the warning is to do with the safety systems which are there to protect the driver. These are all controlled by the 12V system. After the battery has been loaded by the pulse box, there can be any amount of time before the vehicle is put into READY. This means if the battery doesn't recover to a level that can keep the 12V supply stable, it could result in the vehicle not powering up properly.

Disclaimer

This help topic is subject to changes without notification. The information within is carefully checked and considered to be correct. This information is an example of our investigations and findings and is not a definitive procedure. Pico Technology accepts no responsibility for inaccuracies. Each vehicle may be different and require unique test settings.

`