The purpose of this test is to investigate the operation of an analog Manifold Air Pressure (MAP) sensor under varied engine operating conditions.
Connection for diagnostic work will vary dependent on application.
Technicians should whenever possible gain access to the test circuit without damage to seals and insulation. If this is not possible then make sure appropriate repairs are completed.
General connection advice
PicoScope offers a range of options within the test kits.
Dependent on difficulty of access, choose from:
Testing sensors and actuators (to include relevant circuit/connectors):
The Manifold Absolute Pressure (MAP) sensor measures the vacuum in the inlet manifold.
This output, when sent back to the engine management system, determines either the fuelling or the amount of vacuum (or light load) advance.
The sensor is a three-wire device with:
This component can be either an integral part of the electronic control module or an individual component. The output from the external sensor shows voltage that rises and falls depending upon the vacuum.
When the engine is stationary or the throttle is wide open, zero vacuum is present and the sensor output is about 5 volts. As a vacuum is applied, the voltage drops. The example waveform shows that, at idle, the output is about 1 volt. As the throttle is opened, the vacuum in the manifold drops and the output voltage rises. In this case the voltage rises to almost 5 volts.
The 'hash' on the waveform is due to the vacuum change from the induction pulses as the engine is running.
Voltages are similar between different manufacturers and a lower-than-anticipated voltage will produce a loss of power due to fuel starvation. Conversely a higher voltage will cause overfuelling and could eventually result in the failure of the catalytic converter if allowed to persist. This high voltage could result from any number of problems but may be as simple as a split vacuum hose or incorrectly adjusted tappet clearances. The voltage from an integral MAP sensor can only be evaluated by a Fault Code Reader (FCR) due to the lack of access to the output voltage.
The Manifold Absolute Pressure (MAP) measures the pressure in the inlet manifold, and is sent back into the engine management system to determine either the fuelling or the amount of vacuum (light load) ignition timing advance. The MAP sensor in most cases measures a negative pressure, but can also be used to measure a positive boost pressure on a vehicle equipped with a turbo charger.
The sensor is a 3-wire device that has:
This component can be either an integral part of the Electronic Control Module (ECM), or an individual component.
The output from the analogue version rises and falls depending upon the vacuum. When the engine is stationary or the throttle is wide open, zero vacuum is present and the output is about 5 volts. As a vacuum is applied this voltage will drop.
Selection of component-related Diagnostic Trouble Codes (DTCs):
P0105 - MAP Sensor Circuit Insufficient Activity.
P0106 - Manifold Absolute Pressure (MAP) System Performance.
P0107 - Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage.
P0108 - Manifold Absolute Pressure (MAP) Sensor Circuit High Voltage.
P0109 - Manifold Absolute Pressure Circuit Intermittent.
This help topic is subject to changes without notification. The information within is carefully checked and considered to be correct. This information is an example of our investigations and findings and is not a definitive procedure. Pico Technology accepts no responsibility for inaccuracies. Each vehicle may be different and require unique test settings.
We know that our PicoScope users are clever and creative and we’d love to receive your ideas for improvement on this test. Click the Add comment button to leave your feedback.